Christie CS50-D100U, Руководство пользователя

Страница: 40 / 116

OPERATION
RPMS, CS50 & CS70-D100U/UF User’s Manual
3-23
Figure 3.11. Adjust Filter
NOTE: Filter affects only the current signal.
H-Position
– This option moves the image to the right or left.
NOTE: 1) The value shown represents where the approximate center of the image
lies in relation to the total number of pixels available horizontally. This varies widely
according to the signal—watch the image while adjusting.
2)
SHORT CUT:
Press
Position
and adjust the top slidebar.)
V-Position – This option moves the image up or down.
NOTE: 1) The value shown represents where the approximate center of the image
lies in relation to the total number of pixels available vertically. This varies widely
according to the signal—watch the image while adjusting. 2)
SHORT CUT :
Press
Position
and adjust the bottom slidebar.
Lens Control
– not available in this projector.
Top, Bottom, Left or Right Blank – By adjusting these options you blank (turns
to black) the top, bottom, left, or right edge of the image so that any unwanted
information is cropped from view. For example, when displaying native size video
you may want to blank out a few of the top lines.
PLL Loop Gain
– This control changes the relative offset to the default gain. The
default PLL Loop Gain setting of 10 is set automatically with a Pixel Tracking
adjustment and is correct in most cases. In rare instances, such as if your image
exhibits tearing or “flag-waving”, increase the PLL loop Gain setting as necessary.
Or, if your image is unstable and “breaks up”, this may indicate that the PLL Loop
Gain setting is either too high or too low. PLL Loop Gain affects the current
channel only.
NOTE: PLL stands for “Phase Lock Loop”.
Keystone – not available in this projector.
Plug & Display (EDID)
– By default the Plug & Display
option detects an incoming digital flat panel video signal and
displays it in the native resolution of your projector. If you have
additional daisy chained projectors they too will display in this
resolution. If you want to use a different resolution (for
example, your graphics card may not support the current
resolution), select a different Plug & Display setting from the list – see right.