Choc Edge Choc Creator V2.0 Plus, Руководство пользователя

Страница: 19 / 44

Choc Edge
19
3.3 Note
3.3.1 Before using your Choc Creator for the first time, please check the printing platform is level
to make sure it has not been affected by shipping of the machine. If the platform appears to
need adjustment, refer to the video on the provided USB flash drive.
3.3.2
Clean the syringe after every use in order to avoid the rubber bung sticking inside the
syringe. If it does stick, put the entire syringe into a bowl of hot water (°C) for a few minutes
and pull the rubber bung out with a pair of tweezers. When the rubber bung wears out, it
can be replaced with the spare that is provided in the tool box.
3.3.3
Ele t i it e ui e e t: The ope ati g oltage of the Cho C eato s po e adapte is
between 100-240V. An unstable voltage or exceeding the range of the operating voltage can
damage the power adapter. A damaged power adapter will not light up when plugged in.
3.3.4 Before printing, put a piece of paper on the platform and fasten it in place using the four
magnets from the tool box. Displacement of the paper will affect the quality of printing.
Additionally, try to avoid placing the magnets close to the metallic nozzle. Placing the four
magnets on all four corners of the paper is the best option.
3.3.5
When printing for the first time, test the machine by printing a square. A Test Square file is
included as one of the pre-loaded design files. (see
Figure 3.3.5
below)
Figure 3.3.5 (Actual photographs)