CHMER Wire-Cut EDM Operation Manual W5F
1-2-4 Introduction of operation key
1.
JOG
If this button is pressed, four kinds of table moving speed are selectable
including H (high speed), M (middle speed), ML (speed between middle and
low) and L (low speed). Under this mode, if the axis-moving key is pressed,
the table will move by setting speed. If it is released, the table will stop
moving.
Note:
1. If the JOG button is pressed twice in 1 second, it will execute AUTO
mode.
2.
The value of JOG feed-rate override may adjust in the mode Help-2
>
「
System Double Value Parameter
」
, PA#36~PA#41 (
We strongly
recommend user may not modify the value at will, otherwise it may
cause unexpected damage to machine tool
)
2.
STEP JOG
If this button is pressed, the table will move by set increment. The set
increments include H (1000µ), M (100µ), ML (10µ) and L (1µ). Under this
mode, if the axis-moving key is pressed one time, the table will move 1
increment distance. If you want 2 increments movement, press the axis-moving
key twice.
1-6