5
substances, mineral oil, alkanes (Such as
gasoline, cleaning lubricants, electronic
resurrection agents), alcohol, certain drugs
(white flower oil, active oil, bone-setting
water, thinner), adhesive sheets that can
generate oxime gas and potting glue (only
for
connectors)
(Such
as
KE200,
CX-200/chemlok, etc.)), TBP (plasticizer),
detergent, etc., to avoid chemical damage
and affect the electrical safety performance
of photovoltaic modules.
It is forbidden to install photovoltaic
modules in windy weather.
It is forbidden to focus sunlight on
photovoltaic modules.
It is forbidden to use photovoltaic modules
in relevant places such as movable platforms
(except for tracking brackets).
It is forbidden to disassemble and move any
part of the photovoltaic module; if the
connector of the photovoltaic module is wet,
do not perform any actions to avoid the risk
of electric shock.
Do
not
connect
or
disconnect
the
photovoltaic module when there is current or
external current from the photovoltaic
module.
The cover of the junction box should always
be kept closed.
Avoid partial shading of photovoltaic
modules for a long time. Otherwise, the
temperature of the shaded solar cells will
rise (hot spot effect), and in severe cases, the
photovoltaic modules may be burned, or
even a fire may occur.
For photovoltaic modules used in deserts or
windy and sandy areas, it is recommended to
use connector dust caps before installation,
or take other measures to prevent sand and
dust from entering the connectors, otherwise
it may cause insertion problems or electrical
safety hazards.
3.2
Operational safety measures
During transportation and storage, avoid
damage or fall of the packaging; ensure that
the packaging box is ventilated, rain-proof
and dry; after arriving at the installation site,
carefully open the outer packaging to
prevent scratches and bumps on the
photovoltaic modules due to improper
unpacking Such phenomena; when stacking
photovoltaic
modules,
the
stacking
requirements must be strictly followed.
Avoid impact or scratches on any part of the
photovoltaic
module,
otherwise
the
reliability and safety of the photovoltaic
