STCS4012 Series Layer 3 Switch Installation Guide
- - 14 - -
www.stephen-tele.com
Figure 5-4 Setting serial port parameters
4) Click <OK> when the serial port parameters are set and the system will enter the Hyper Terminal interface.
5.4 Booting Switch
5.4.1 Checking before Powered on
Before powering on switch, check:
Whether the power cord is correctly connected.
Whether the voltage is consistent with that required by the switch.
Whether the Console cable is correctly connected, the PC or terminal for configuration has been started, and the
configuration parameter setting is completed.
5.4.2 Powering on and Booting
After the switch is powered on, first run the BOOTROM program, and the terminal yields the following output:
Stable and Portable Route Operating System(SPROS) Boot
Copyright(c) 2002-2010,Any-RB0
Complied in April 2004
Version 4.50
System start-up time Sep 16 2004, 11:06:37
Press any key to enter rom mode.
asks if the user wants to enter BOOT menu. 3 seconds are given for your selection:
If you press any key within the 3 seconds, the program will access the BOOT menu.
If you do nothing within the 3 seconds, system will enter the auto-booting state when the time prompt for instruction waiting
becomes 0.
The auto-booting interface of the system is as follows:
auto-booting...
Loading /rfa1/SPROS_KERNEL_010.Z ... Uncompressing 2393601 bytes...
Loading image... 10441888
