WBM3E
Installation Instructions
6
ASSEMBLY AND INSTALLATION
The WBM3E will allow an interactive whiteboard to be installed
over an existing chalkboard or whiteboard. The WBM3E has
telescoping legs which allows it to be anchored above and
below the existing chalkboard or whiteboard, or anchored
above the existing chalkboard or whiteboard with the lower
extension resting against the existing board.
Assembling WBM3E Legs
NOTE:
Before assembling legs, determine the type of
installation required.
•
Proceed to
Using Adjustable Leg
section if
the WBM3E will be anchored both above and
below the existing chalkboard or whiteboard.
•
Proceed to
Using Alternate Foot
section if
the WBM3E will be anchored above the
existing chalkboard or whiteboard with the
lower foot resting against the existing board.
Using Adjustable Leg
1.
Slide adjustable leg (N) up over bottom of upright assembly
(D). (See Figure 1)
2.
Adjust leg (N) as necessary to set the correct length of entire
leg assembly. (See Figure 1)
3.
Fasten adjustable leg (N) in place using three knobs and
three 1 1/8” spacers (T). (See Figure 1)
NOTE:
Three knobs and spacers should be used on each leg
assembly. If necessary, two knobs may be used,
at a
minimum
.
4.
Repeat Steps 1 through 3 on the other upright assembly
(D).
5.
Proceed to
Locate Mounting Site section
.
Figure 1
Using Alternate Foot
1.
Install M6x40mm knob (X) into hole on alternate foot (P).
(See Figure 2)
2.
Place alternate foot (P) over bottom of upright assembly
(D). (See Figure 2)
3.
Fasten alternate foot (P) to upright assembly (D) using four
M4 x 08mm Phillips head screws (Q). (See Figure 2)
4.
Repeat Steps 1 and 2 on the other upright assembly (D).
Figure 2
Locate Mounting Site
WARNING:
IMPROPER INSTALLATION CAN LEAD TO
MOUNT FALLING CAUSING SEVERE PERSONAL INJURY
OR DAMAGE TO EQUIPMENT! It is the installers
responsibility to make certain the structure to which the
mount is being attached is capable of supporting five times
the weight of the WBM3E and all attached equipment not to
exceed 125 lbs (56.7 kg).
WARNING:
ELECTRICAL SHOCK, EXPLOSION AND
FIRE HAZARD! CUTTING OR DRILLING INTO
ELECTRICAL CORDS, CABLES OR GAS PLUMBING CAN
CAUSE DEATH OR SERIOUS PERSONAL INJURY!
ALWAYS make certain area behind mounting surface is free
of electrical wires, cables, gas, water, waste, or any other
plumbing before drilling or installing fasteners.
(D)
1
(N)
2
3
(D)
(N)
(R) x 3
(T) x 3
(D)
3
(Q) x 4
2
(P)
(X)
1
