WBM3E
Installation Instructions
10
Completing Attachment to Wall (using
adjustable leg only)
NOTE:
See
Adjustments
section to make any necessary
adjustments
BEFORE
completing attachment to wall.
NOTE:
The lower part of the WBM3E must be attached to the
wall using the correct hardware for the wall type. It may
be attached to a wood stud wall or a concrete or
concrete block wall. Proceed to appropriate section for
instruction.
NOTE:
If installing to a wood stud wall, drywall anchors (Y) are
required if the adjustable legs do not align with the
wood studs after they are attached to the display.
Wood Stud Wall (if legs are aligned with studs)
1.
Mark the wall over wood stud through the adjustable leg (N)
on each upright assembly. (See Figure 12)
2.
Drill one 1/8” pilot hole in wood stud. (See Figure 12)
3.
Use one 1/4-20 x 2-1/2” lag bolt (V) and one 1/4” flat washer
(U) to attach adjustable leg (N) to wall. (See Figure 12)
4.
Repeat Steps 2 and 3 for other adjustable leg (N).
Figure 12
Wood Stud Wall (if legs are NOT aligned with studs)
1.
Mark the wall on drywall through the adjustable leg (N) on
each upright assembly. (See Figure 13)
2.
Drill a 1/2” hole at each marked location. (See Figure 13)
Figure 13
3.
Hold metal channel on anchor (Y) flat alongside plastic
straps and slide channel through hole. (See Figure 14)
Figure 14
4.
Holding plastic straps on anchor (Y), pull anchor away from
wall until channel rests flush behind wall. (See Figure 15)
5.
Slide plastic cap on anchor (Y) towards wall until flange of
cap is flush with wall. (See Figure 15)
Figure 15
6.
Snap off plastic straps on anchor at wall by pushing side to
side, snapping off straps level with flange of plastic cap.
(See Figure 16)
7.
Repeat steps 3 through 6 for remaining mounting hole.
Figure 16
3
(V) x 2
(N)
2
x 2
wood stud
(U) x 2
1
(N)
1
2
(Y) x 2
Drywall
Plastic Straps
3
Plastic Cap
Drywall
Anchor Metal Channel
(Side View)
5
(Y) x 2
4
Plastic Straps
Drywall
Anchor Metal Channel
Plastic Cap
(SIDE VIEW)
6
