Installation Instructions
WBM3E
11
8.
Use two 1/4-20 x 1 3/4” Phillips pan machine screws (Z) and
two 1/4” flat washers (U) to attach both adjustable legs (N) to
anchors in wall. (See Figure 17)
Figure 17
Concrete or Concrete Block Wall
1.
Mark the wall through the adjustable leg (N) on each upright
assembly (D). (See Figure 18)
Figure 18
2.
Drill one 1/4” x 2-3/4” pilot hole at marking. (See Figure 18)
3.
Install a Toggler (W) into pilot hole using a hammer. (See
Figure 18)
4.
Use one 1/4-20 x 2-1/2” lag bolt (V) and one 1/4” flat washer
(U) to attach adjustable leg (N) to anchor in wall. (See
Figure 18)
5.
Repeat Steps 2 through 4 for other adjustable leg (N).
Adding Covers
1.
Open the lower flaps of the wall bracket cover (L) outward.
(See Figure 19)
2.
Slide the cover downward, hooking the top of the wall
bracket covers (L) onto the tabs on top of wall assembly
brackets. (See Figure 19)
3.
Slide the lower flaps of the wall bracket cover (L) under the
bottom of the wall assembly brackets (K). (See Figure 19)
Figure 19
4.
Slide the sliding cover (M) down over the wall bracket cover
(L) on both wall assembly brackets. (See Figure 20)
Figure 20
(Z) x 2
(A)
(U) x 2
8
1
3
(W) x 2
2
4
(V) x 2
(N)
(U) x 2
1
1
2
Wall
bracket
tab
(L)
(K)
(M)
(L)
(M)
4
