CHIEF SL-100, Инструкция по эксплуатации

Страница: 2 / 32

Instruction Manual SMART-LIFT Electric Ceiling Lifts
1
IMPORTANT WARNINGS and CAUTIONS!
WARNING: A WARNING alerts you to the possibility of serious injury or death if you do not follow the instructions.
CAUTION: A CAUTION alerts you to the possibility of damage or destruction of equipment if you do not follow the corre-
sponding instructions.
• WARNING: Improper installation can result in serious personal injury! Make sure that the ceiling structural mem-
bers can support a redundant weight factor
five times the total weight of the equipment. If the ceiling can not support
this weight, reinforce the ceiling before installing the lift.
• WARNING: Be aware during the installation that this is a motorized device, and there are pinch points for people and
for electrical wiring.
• WARNING: Be aware of the potential for personal injury or damage to the lift if it is not adequately mounted. The lift
(without a projector) weighs about 65 lbs (30 kg).
• WARNING: Plenum rating requires the unit to be hard wired through the provided strain relief, use of Class II control
wiring, and all open holes in housing (except joist tabs) must be sealed using foil tape.
• WARNING: Be sure the lift is installed square and parallel in all dimensions to avoid personal injury or damage to the
lift. Avoid stressing the lift at any time during installation.
• WARNING: Electrical outlets must be installed by a qualified electrician. Follow all electrical codes.
• CAUTION: Test the lift for shipping damage. See “Pretest the lift Before Installing,” on page 3.
• CAUTION: Never close lift while projector is running or while projector is in “cool down” operation.
TOOLS REQUIRED FOR INSTALLATION
• Phillips screwdrivers, No. 1 and No. 2
• Electric drill and bit set
• Pliers (heavy-duty)
• Electrical wire cutter/stripper
• If suspended from threaded rods: Socket set with extension
NOTE: Other tools may be required depending on the
method of installing the lift in the ceiling.
CONTENTS
DIMENSIONAL DRAWING ......................................... 2
INSTALLATION .......................................................... 3
Pretest the Lift Before Installing............................ 3
Prepare the Ceiling Opening and Install the Lift ... 4
Install the Projector on the Lift .............................. 9
Adjustments .......................................................... 10
Install the Controller.............................................. 11
Connect the Control Wiring .................................. 11
Connect the Lift to the Power Supply ................... 12
Installing Wiring Cover (Optional)......................... 13
OUTSIDE TERMINAL WIRING EXAMPLES .............. 14
INSIDE TERMINAL WIRING EXAMPLES .................. 20
TROUBLESHOOTING ................................................ 26