CHIEF SL-100, Инструкция по эксплуатации

Страница: 12 / 32

Instruction Manual SMART-LIFT Electric Ceiling Lifts
11
INSTALL THE CONTROLLER
WARNING: Plenum rating requires hardwiring through the
provided strain relief, use of Class II control wiring, and all
open holes in housing (except joist tabs) must be sealed using
foil tape. See wiring instructions in this manual and follow all
local building and electrical codes.
Select the desired location for mounting the controller:
• Attached to the top of the lift,
• Mounted inside the plenum in the ceiling, or
• Remote-mounted.
Refer to the instructions supplied with the controller.
CONNECT THE CONTROL WIRING
Unplug the lift’s power cord. Remove the jumper and push button from the external terminal block that you installed
when pretesting the lift (page 2).
WARNING: Plenum rating requires hardwiring through the
provided strain relief, use of Class II control wiring, and all
open holes in housing (except joist tabs) must be sealed using
foil tape. See wiring instructions in this manual and follow all
local building and electrical codes.
Connect the control wiring according to the instructions supplied with the controller. Refer also to the wiring examples
and terminal function tables on the following pages.
Feed the video and/or communication cable through the 1-3/8-in. dia. hole on the rear of the lift housing, and connect it
to the projector.
Leave enough slack in the cabling to allow for up and down travel.
If necessary, install a manual push button to control the opening and closing of the lift.
Refer to the controller instructions for connection options. You can use either the internal or external terminal block to
control the SMART-LIFT.
NOTE: On the Model 100, both plugs of the internal receptacle are on continuously. On the Model 150, one plug turns
on or off per position and one plug stays on continuously.