RPA Elite Series Projector Mount
Installation Instructions
10
1
X 6
X 6
2
PROJECTOR INSTALLATION
IMPORTANT ! :
Model RPM uses Chief "SLB"
Series interface brackets and Models RPM-A,
RPM-B and RPM-C use Chief "SLM" Series
interface brackets.
Install Interface Bracket
NOTE:
If a model RPM-A, RPM-B, or RPM-C is being
installed, the interface bracket will be shipped
with thumb nuts attached and locked into place.
If this is the case proceed to Step 2a below.
Both the interface bracket and amount of
hardware will vary dependent on projector
model.
1.
Assemble six Phillips flat head screws into bottom
of interface bracket.
2.
Thread six thumb nuts onto six Phillips flat head
screws until screw end is visible in top of thumb
screw.
IMPORTANT ! :
DO NOT fully tighten thumb
screws at this time.
Threaded Rod Installation
The RPM can be secured to unistrut, angle or channel
assembly overhead structural members (trusses or I-
beams) using four 1/4” diameter threaded rods.
WARNING:
IMPROPER INSTALLATION CAN
RESULT IN SERIOUS PERSONAL INJURY OR
DAMAGE TO EQUIPMENT! Structural members
MUST
be capable of supporting five times the
combined weight of all equipment being mounted.
1.
Carefully determine required mount position.
IMPORTANT ! :
This will require knowing the lens
to screen distance. See projector specifications
for determaning this distance.
NOTE:
Threaded rod and installation hardware not
included.
2.
Secure one end of the threaded rod to the structural
member.
3.
Install four 1/4-20 jam nuts on each threaded rod.
4.
Install the RPA on the threaded rod.
NOTE:
Holes in the RPA allow socket wrench access
without unit disassembly.
5.
Secure the RPM to the threaded rod using four
1/4-20 nuts.
1c
1
2
4
X 4
5
(A)
(B)
Example Only
(Interface bracket
varies dependent
on projector model)
