Installation Instructions
PSMH2465
5
ASSEMBLY AND INSTALLATION
The PSMH2465 is designed to allow the display to be mounted
in either the Landscape or Portrait mode on either a 16" or 24"
on-center wood stud or steel stud wall.
NOTE:
Decide whether the PSMH2465 will be used in either
the Landscape or Portrait mode, and proceed to either
Landscape Mount
or
Portrait Mount
section.
Landscape Mount
Attaching Locking Flags
1.
Attach locking flag (C) to wall mount (A) right vertical
bracket using one 10-24 x 1/2" button head cap screw (E),
one .194 x .375 x .032" spacer (H), and one 10-24 lock nut
(G) through lower hole on locking flag and upper hole on
wall mount right vertical bracket. Repeat with wall mount left
vertical bracket. (See Figure 1)
Figure 1
Attaching Mount to Wall
Wood Stud Wall
WARNING:
IMPROPER INSTALLATION CAN LEAD TO
DISPLAY FALLING CAUSING SERIOUS PERSONAL
INJURY OR DAMAGE TO EQUIPMENT! It is the installer’s
responsibility to make sure the structure to which this mount
is being attached can support a minimum of 900 lbs
(408.2 kg). Reinforce the structure as required before
installing this mount.
1.
Place wall mount (A) against wall in desired installation
location. (See Figure 2)
2.
Level and adjust horizontal position making certain slots in
the horizontal brackets are properly positioned over studs.
(See Figure 2)
3.
Using a pencil or similar marking tool, mark the location of
mounting holes in horizontal brackets onto surface. (See
Figure 2)
4.
Drill four 7/32" pilot holes at marked locations.
(See Figure 2)
Figure 2
5.
Secure wall mount (A) to studs using four 5/16 x 2-1/2" hex
head lag screws (J) and four 5/16" flat washers (K).
(See Figure 3)
Figure 3
NOTE:
Proceed to
Installing Display
section.
1
(A)
(E) x 1
(C)
(G)
(H)
(Landscape Mount-Right Vertical Bracket Shown)
3
4
x 4
5
(J) x 4
(K) x 4
(A)
