Installation Instructions
PSMH2465
9
Portrait Mount
1.
Attach locking flag (B) to wall mount (A) vertical bracket
using one 10-24 x 1/2" button head cap screw (E), one
.194 x .375 x .032" spacer (H), and one 10-24 lock nut (G)
through lower hole on locking flag and upper hole on wall
mount vertical bracket. Repeat with lower hole on wall
mount vertical bracket. (See Figure 13)
Figure 13
Attaching Mount to Wall
Wood Stud Wall
WARNING:
IMPROPER INSTALLATION CAN LEAD TO
DISPLAY FALLING CAUSING SERIOUS PERSONAL
INJURY OR DAMAGE TO EQUIPMENT! It is the installer’s
responsibility to make sure the structure to which this mount
is being attached can support a minimum of 900 lbs
(408.2 kg). Reinforce the structure as required before
installing this mount.
1.
Place wall mount (A) against wall in desired installation
location. (See Figure 14)
2.
Level and adjust horizontal position making certain
horizontal slots on the vertical brackets are properly
positioned over studs. (See Figure 14)
3.
Using a pencil or similar marking tool, mark the location of
mounting holes in vertical brackets onto surface. (See
Figure 14)
4.
Drill four 7/32" pilot holes at marked locations.
(See Figure 14)
Figure 14
5.
Secure wall mount (A) to studs using four 5/16 x 2-1/2" hex
head lag screws (J) and four 5/16" flat washers (K).
(See Figure 15)
Figure 15
NOTE:
Proceed to
Installing Display
section.
(Portrait Mount-Top of Vertical Bracket Shown)
(B)
(G)
(H)
1
(E) x 1
(A)
3
4
x 4
5
(J) x 4
(K) x 4
(A)
