MSP-TEQ9
Installation Instructions
6
ASSEMBLY AND INSTALLATION
The MSP-TEQ9 will allow an interactive whiteboard to be
installed over an existing chalkboard or whiteboard. The MSP-
TEQ9 has telescoping legs which allows it to be anchored above
and below the existing chalkboard or whiteboard, or anchored
above the existing chalkboard or whiteboard with the lower
extension resting against the existing board.
Assembling MSP-TEQ9 Legs
1.
Slide adjustable leg (N) up over bottom of upright assembly
(D). (See Figure 1)
2.
Adjust leg (N) as necessary to set the correct length of entire
leg assembly. (See Figure 1)
3.
Fasten adjustable leg (N) in place using three knobs (R) and
three 0.75x.265x1.125 spacers (T). (See Figure 1)
NOTE:
Three knobs and spacers should be used on each leg
assembly. If necessary, two knobs may be used,
at a
minimum
.
4.
Repeat Steps 1 through 3 on the other upright assembly
(D).
Figure 1
Assembling Brackets to Legs
1.
Lay two upright assemblies (D) on floor along side of
whiteboard.
2.
Determine where to fasten upper whiteboard hanger
bracket (Z) to upright assemblies (D).
3.
Fasten one whiteboard hanger bracket (Z) in upper position
using one knob (R) and one 0.75x.265x1.125 spacer (T) on
each upright assembly (D). (See Figure 2)
Figure 2
4.
Fasten one whiteboard hanger bracket (Z) near lowest
position of upright assembly using one knob (R) and one
0.75x.265x1.125 spacer (T) on each adjustable leg (N) at
bottom of upright assembly (D). (See Figure 4)
NOTE:
The length of the assembly will be adjusted in a later
step.
Figure 3
(D)
1
(N)
2
3
(D)
(N)
(R) x 3
(T) x 3
3
(T) x 2
(R) x 2
(Z)
(D)
(D)
3
(T) x 2
(R) x 2
(Z)
(D)
(N)
