Model: MSP-DCCFTP-Series
Installation Instructions
4
2.
Assemble pole clamp back (150) to pole mount front
using two FW (160) and two BHCS (170) using a
5/32" hex key. (see Figure 4)
3.
Secure pole mount back (150) to pole mount front and
pole by tightening two BHCS (170) using a 5/32" hex
key.
4.
Add pipe cap (200) to top of pole.
Figure 4: Assemble Array Rail to Pole
Display Installation
Attach Centris Head to Flush Mount Display
CAUTION!
If display uses a screw size other than those included
in the kit, DO NOT use the screws provided. Using the
wrong screws could result in damage to your monitor.
1.
Install two M4 x 12mm Phillips pan head screws (110)
into two upper mounting holes in display back.
(see Figure 5)
NOTE:
DO NOT fully tighten at this time.
2.
Hang display on Centris head. (see Figure 6)
3.
Install bottom two M4 x 10mm Phillips pan head
screws (110) through Centris head mounting holes
and into lower mounting holes in display back.
4.
Tighten ALL four M4 x 10mm Phillips pan head
screws (110). (see Figure 7)
Figure 5: Prepare Display
Figure 6: Hang Display
Pole Clamp Back (150)
Pole
(160)
(170)
Pole Mount front
with Array
Display
(110)
Display
Centris Head
(10, 20, 180)
