3
2-2-2. Spot welding
Diagram 2
1. Washer contact to work piece
2. Discharge-arc
3. Finish welding
Diagram 1
1. The stud screw press
the base metal
2. electric discharge,
start arc
3. Stud welding complete
2-2. Stud welding and spot welding
2-2-1. Stud welding
When mounting the stud, the stud must extend past the three support legs about 2mm. Confirm the stud welding position.
Press the support legs on the work piece firmly. Make sure the work piece is smooth and clean. Press the torch trigger.
The stud screw will be welded on the base metal immediately. Check the stud welding strength. If the strength is not
sufficient, adjust the torch pressure, recharge, and repeat the steps. Traditional method such as rivets, lock screws, and
common welding typically damages the base metal. The stud welding process does not damage the base metal.
Using this specific welding function heat will not affect the back side of work piece. The back of the work
piece will have a good appearance.
2-3. Stud welding visual test
Please refer to the pictures below for stud welding results. If the stud welding results are unsatisfactory adjust the power,
torch head pressure, or torch head height according to the instructions. (
Note:
only adjust one parameter at a time.)
1.
Voltage not enough
2.
Correct voltage
3.
Too high voltage