CHIEF LBM Series, Руководство по установке

Страница: 12 / 20

LBM Series Installation Instructions
12
Column Add-On Installation (LBM3X3U/
LBM2X2UP/LBM3X2UP only)
1. Insert one column add-on (V) to each column (M) making
sure holes are lined up on each side. (See Figure 4)
2. Use 5/32" hex key (J) and six 1/4-20 x 1/2" flat head cap
screws (W) to secure each column add-on (V) to each
column (M). (See Figure 4)
Figure 4
Rails Installation
1. Using display dimensions, determine where the center of
the top displays will be on the cart.
IMPORTANT ! : Install all column add-ons (V), if
applicable, prior to installing rails to columns.
2. Place clamp brackets (P) on columns in the position of
where the center of the top displays will be on the cart with
the diamond on the brackets being placed at the exact
center location. (See Figure 5)
Figure 5
3. Use 5/16-18 x 4 1/2" button head cap screw (AA), two 5/16"
washers (CC) and 5/16-18" lock nut (FF) to secure each
clamp bracket (P) to column. (See Figure 5)
NOTE:
Clamp brackets (P) may be flipped in order to use long
slots for installation if necessary. (See Figure 6)
Figure 6
NOTE:
If installing LBM3X1UP, proceed ahead to Step 6.
4. Measure one screen height down from center point on
installed clamp brackets to determine mounting location of
lower clamp brackets. (See Figure 7)
5. Use 5/16-18 x 4 1/2" button head cap screw (AA), two 5/16"
washers (CC) and 5/16-18" lock nut (FF) to install clamp
brackets for lower displays with center diamond one screen
height below center diamond of upper installed brackets.
(See Figure 7)
NOTE:
If some clearance is desired in between displays, install
lower brackets slightly more than one screen height
below upper brackets.
(rear view)
(V)
1
2
(W) x 6
(M)
2
2
(rear view)
(AA)
(FF)
3
3
(CC) x 2
center of top displays
flipped bracket