Installation Instructions
LBM Series
11
Assembly And Installation
Bolt Down Columns to Floor
1.
Lay array columns (M) down on a flat surface.
2.
Use four 5/16-18 x 1 1/2" flat head cap screws (R) to
connect each bolt down plate (J) to each columns (M). (See
Figure 1)
IMPORTANT ! :
Inside bolt pattern is NOT square!
Corners of front of plate have larger radii than corners on
back of plate. Plate must be properly aligned in order to
attach to column.
Figure 1
3.
Using template found at end of this instruction manual
(Figure 20), mark four holes at outside hole locations for
each column. (See Figure 2) and (See Figure 21)
WARNING:
Do NOT install LBM Series mounts to any
surface other than concrete! Concrete flooring must be at
least 4" in thickness and NOT be covered with any other type
of flooring material. Concrete anchors must be installed
directly into concrete surface.
IMPORTANT ! :
See Bolt Down Dimensions on page 6 to
measure distances between each bolt down plate.
IMPORTANT ! :
Make sure columns will be installed far
enough away from any walls so that displays may be
installed.
4.
Using a 3/8" drill bit, drill a hole 3 3/8" in depth at each
marked location. (See Figure 2) and (See Figure 3)
5.
Blow each hole clean of any concrete debris with a large air
hose or compressed air in a can. (See Figure 3)
IMPORTANT ! :
Do NOT modify the anchors or advance
the bolt in the anchors prior to installation!
6.
Place each bolt down plate (J) on top of drilled holes making
sure holes on plate are aligned with drilled holes. (See
Figure 3)
7.
Use a hammer to drive anchors (U) through plate holes into
the drilled holes until the bolt head is firmly seated against
the plate. (See Figure 2) and (See Figure 3)
8.
Tighten each anchor by turning the head three to four turns
past finger tight. (See Figure 3)
Figure 2
Figure 3
9.
Repeat Steps 4-8 for additional column(s).
2
(R) x 4
(M)
(J)
larger radii in front
7
3
4
3/8"
6
(U) x 4
7
4
3/8"
3 3/8" deep
5
air hose
(U) x 4
7
(J)
(U) x 4
8
(J)
Содержание LBM Series
Страница 18: ...LBM Series Installation Instructions 18 Figure 21 FRONT ...
Страница 19: ...Installation Instructions LBM Series 19 ...
