Installation Instructions
KFCD
7
CABLE MANAGEMENT
WARNING: Make sure your cables do not run through a pinch
point.
1. Route power/audio/video cables under each arm, allowing suf-
ficient slack in cables for extension and avoiding pinch points
2. Secure cables using cover plates and four screws (see “DRAW-
INGS” on page 2).
ADJUSTMENTS
CAUTION: Overtightening adjustment will cause excessive
wear.
Rotational Tilt, Pitch, and Roll Adjustment
1. If necessary, use a Phillips screwdriver to tighten or loosen the
Phillips pan head screw (see “DRAWINGS” on page 2).
2. Check for desired tension.
3. Repeat Steps 1 and 2 until desired tension is obtained.
Lateral Tension Adjustment
1. Using a 3/16” hex wrench (provided), slightly tighten or loosen
lateral tension adjustment bolt (see “DRAWINGS” on page 2).
2. Check for desired tension.
3. Repeat Steps 1 and 2 until desired tension is obtained.
Arm Tension Adjustment
1. Using a 3/16” hex wrench (provided), slightly tighten or loosen
arm tension adjustment bolt (see “DRAWINGS” on page 2).
2. Check for desired tension.
3. Repeat Steps 1 and 2 until desired tension is obtained.
