Installation Instructions
KFCD
3
INSPECT THE UNIT BEFORE INSTALLING
WARNING: Watch for pinch points. Do not put your fingers
between movable parts.
1. Carefully inspect the KFCD for shipping damage. If any dam-
age is apparent, call your carrier claims agent and do not con-
tinue with the installation until the carrier has reviewed the
damage.
NOTE:
Read all instructions before starting installation.
2. Lay out components to ensure you have all the required parts
before proceeding (see KFCD drawing on page 2).
KFCD INSTALLATION
WARNING: It is the responsibility of the installer to verify that
the surface to which the KFCD is anchored will
safety support the combined load of all attached
components and equipment.
Install the KFCD as follows:
1. Determine the exact mounting location prior to installation,
considering the unit’s swing and extension radius.
WARNING: Improper installation can result in serious per-
sonal injury! Make sure that the structural mem-
bers can support a redundant weight factor
five
times
the total weight of the equipment: if not,
reinforce the structure before installing the
KFCD.
Edge Clamp (Default)
1. Using the 3/16” hex wrench (provided), loosen the clamp wide
enough to fit over the edge of your table top or work surface
(see Figure 1).
WARNING: Watch for pinch points. Do not put your fingers
between movable parts.
2. Slide the base over the edge of your table top or work surface
(see Figure 2).
3. Using the 3/16” hex wrench (provided), secure the KFCD by
tightening the clamp bolt.
Grommet Clamp (2” - 3” Diameter Hole)
WARNING: Watch for pinch points. Do not put your fingers
between movable parts.
1. Remove three screws and the base bracket from the bottom of
the desk clamp (see Figure 3).
Clamp Bolt
Clamp
Figure 1. Loosen Clamp
Screws
Base Bracket
Figure 3. Remove Base Bracket
Figure 2. Slide Over Work Surface
