17
LIFT
Position
UP
LOCK
RELEASE
DOWN
Figure 30
Figure 31
Figure 32
Figure 33
To Raise Machine After Loading
1. Turn off all auxiliary line valves or disconnect all tower
and auxiliary cylinders from system, Figure 30.
2. Rotate switch on pendant to “LIFT” position,
Figure 31.
3. Activate pump by depressing and holding “UP” button
on hand-held pendant. Rear cylinder will rise until
machine is level. Once machine is level, both cylinders
will rise together, Figure 32.
4. After machine is above desired working height, release
“UP” button on hand-held pendant to stop flow of
hydraulic fluid from pump. Depress and hold “DOWN”
button on hand-held pendant to lower machine into
mechanical stops, Figure 33.
CAUTION:
1. Before raising machine, verify that vehicle parking
brake is set and automatic transmission is in park (if
equipped).
2. DO NOT walk behind machine during raising
procedures.
3. Install wheel chocks at front of front tire and rear of
rear tire.
PHOENIX
USERS MANUAL
