Chicco iSize, Руководство пользователя

Страница: 18 / 128

18
The child car seat must always be installed
rear facing up to 15 months of age of the
child.
Chicco i-Size may be installed forward fac-
ing if the child is older than 15 months of
age. Nevertheless, Chicco recommends us-
ing Chicco i-Size in rear facing position for
the longest amount of time possible.
WARNING! Deactivate the passenger airbag
when the child is in the front seat in rear fac-
ing direction.
WARNING! Activate the passenger airbag
when the child is in the front seat in forward
facing direction and position the seat in the
most retracted position possible.
The child car seat must be installed only us-
ing the Isofix base provided, in the positions
shown in the vehicle instruction manual.
Before installation of Chicco i-Size, check
that the car is fitted with Isofix anchorage
points, which will be found between the
backrest and seat of the car.
Chicco i-Size can be installed in all car mod-
els in which the manufacturer of the vehicle
states compatible with the i-Size systems in
the manual and also in the models specified
in the attached manual “List of compatible
vehicles.”
4. CAR INSTALLATION OF THE ISOFIX
BASE
Position the Isofix base on desired seat and
fasten the Isofix connectors to the anchor-
age points found between the backrest
and the car seat (fig. 4). You will hear a “click”
when the connectors fit into place.
WARNING! Make sure that the seat is locked
in place correctly by moving the base in the
opposite direction.
Position the support leg (L) and adjust it
using the specific length adjust knob (M)
(fig. 5). The green indicator at the end of
the leg and an acoustic device will beep 5
times consecutively to indicate the correct
position of the leg (fig. 6).
After performing the above operations,
perform the operation shown in figure 5
once again if the leg is not secure due to
the shape of the seat; therefore, increase the
position of the support leg length (L) by one
stop by using the length adjust knob (M).
WARNING: The end of the leg must rest fully
on the vehicle floor (Fig. 7).
WARNING: The leg is not correctly installed
if the indicator remains in the red area and
the acoustic device does not beep 5 times
consecutively. Repeat the installation.
Pull the levers (R) as in figure 8 to remove
the base from the seat.
5. CAR SEAT INSTALLATION
3&"3
FACING (67–105 cm)
WARNING: The child car seat must always be
installed rear facing up to 15 months of age
of the child.
WARNING: when installing in rear facing
position, the child car seat must be tilt-
ed in its maximum position (see chapter
9). ADJUSTING THE INCLINATION OF THE
CHILD CAR SEAT).
Turn one of the Isofix system knobs (K) lo-
cated on both sides of the child car seat so
that the arrow points to an open padlock
(fig. 9).
Install the child car seat onto the Isofix base
in rear facing position, making sure that the
it is anchored into its securing points by
pushing downward (fig. 10).
If the operation has been performed cor-
rectly, it will be possible to turn the locking
knob with the arrow pointing to the closed
padlock (fig. 11).
Push the child car seat firmly against the
backrest of the car seat (Fig. 12) to ensure
maximum adherence of the rotation lock
bar (O).
WARNING: check that the child car seat does
not slide on its base, repeat the operation if
there are any doubts.
WARNING: make sure that the seat is an-
chored correctly by attempting to lift the
child car seat; repeat the operation if there
are any doubts.
To remove the child car seat from the base,
turn the locking knob onto the open pad-
lock and lift the seat.
6. CAR SEAT INSTALLATION FORWARD
FACING (84–105 cm)
Turn one of the Isofix system knobs (K) lo-
cated on both sides of the child car seat so
that the arrow points to an open padlock
(fig. 13).