Chicco 2easy, Инструкция по эксплуатации

Страница: 18 / 148

18
M. Shoulder straps
N. Child car seat restraint harness
O. Buckle
P. Harness adjustment button
Q. Harness adjustment strap
Fig. D – CHILD CAR SEAT VIEW FROM ONE SIDE
R. Seat
S. Diagonal seat belt guide (installation Gr 0+)
T. Diagonal seat belt guide (installation Gr 1)
Fig. E – BOTTOM OF CHILD CAR SEAT
U. Front anchor bar
V. Rear anchor bar
Fig. F – REDUCER CUSHION
Z. Fastening buttons
X. Pockets
1.4 RESTRICTIONS AND REQUIREMENTS
REGARDING THE USE OF THE PROD-
UCT AND CAR SEAT
WARNING! Strictly comply with the following
restrictions and requirements for use concern-
ing the product and car seat: safety will not be
guaranteed otherwise.
• This child car seat is only approved for use
for children that weigh between 0 and 18 kg
(from birth up to 3 years of age, approximate-
ly).
• The vehicle’s seat must be equipped with
3-point safety harness, whether static or with
a retractor, approved according to UN/ECE
Regulation no. 16 or other equivalent stand-
ards (Fig. 1).
• WARNING! If it is used in a vehicle equipped
with rear safety harnesses with integrated air-
bags (inflatable seat belts), the interplay be-
tween the inflatable portion of the seat belt
and this child restraint system could cause
serious injury or death. Do not install this child
restraint equipment where an inflatable safety
harness must be used.
• WARNING! Never fit the child car seat to a ve-
hicle seat that is only equipped with a 2-point
safety belt (Fig. 2).
• The child car seat can be fitted on the front
passenger seat or any other back seat. Nev-
er use this child car seat on rear-facing or
side-facing car seats (Fig. 3).
• This product is expressly intended to be used
only as a child car seat; it should not be used
indoors.
2. CAR INSTALLATION
2.1 INSTALLATION AND REMOVAL OF THE
BASE
INSTALLATION
Proceed as directed to install the Base:
1. Install the Base on the desired seat, pulling the
base button (A) located on the top of the Base.
This enables you to open the tensioner plate (B)
and make use of the recessed handle (Fig. 4).
2. Insert just the abdominal portion of the car’s
three-point harness following the seat belt
path (I) (Fig. 5) and the central seat belt path
(J) (Fig. 6), then pull the seat belt to the op-
posite seat belt path (I) (Fig. 7), and fasten the
car seat belt.
WARNING! The diagonal portion of the three-
point car seat belt should not be inserted into
the Base.
3. Close the tensioner plate (B) ensuring that the
base button (A) is completely back in its seat.
(Fig. 8)
WARNING! NEVER fit the car seat belt in any
way not mentioned in these instructions.
WARNING! Always check that the seat belt is
distributed evenly at all points and that it is not
twisted.
WARNING! Ensure that the hook has been fas-
tened correctly, checking that the indicator on
the base button (A) is not red.
REMOVAL
Pulling on the base button (A) will enable you
to open the tensioner plate (B) and make use of
the recessed handle (Fig. 4). At this point, unfas-
ten the three-point car seat belt and remove it
from the seat belt guides.
2.2 INSTALLING THE CHILD CAR SEAT TO
THE BASE
INSTALLATION FOR GROUP 0+ (0-13 kg)
WARNING!
When used for Gr. 0+ (0-13 kg),
always install the child car seat in the rearward
facing position. If the front seat of the car is