Page 18
SKU 98838
For technical questions, please call 1-800-444-3353.
FiGuRE F
OiL DiPSTicK
(65A)
PLuG
(59A)
4.
Engine maintenance:
After first 5 to 8 hours of use:
a.
Change oil. Then, change oil every 50 hours of
use. Change oil every 25 hours of use when operating the Engine under a heavy
load or in high temperatures. To change the oil, remove the Plug (59A) and allow
the old oil to drain in a proper container. Once drained, replace the Plug. If the
Engine will be run in temperatures
above
32° Fahrenheit, use
SAE 30
weight oil.
If the Engine will be run in temperatures
below
32° Fahrenheit, use
SAE 5W-30
weight oil. To fill the Engine crankcase with new oil,
unscrew
and remove the Oil
Dipstick (65A). Pour engine oil into the oil fill hole until the level of oil is even with
the bottom edge of the oil fill hole (if you cannot see the oil through the oil fill hole,
then the oil is too low and more oil must be added). Make sure to screw the Oil
Dipstick (65A) firmly back into its Dipstick Hole. Also, make sure to dispose of the
old oil according to local waste disposal requirements.
(See Figure F.)
AiR FiLTER cOVER
(18A)
AiR FiLTER ELEMENT
(19A)
AiR FiLTER SEPARATOR
(20A)
Figure G
SPARK PLuG (28A)
SPARK PLuG WiRE (36A)
b.
After every 25 hours of use:
Service the Air Filter Element (19A) and Air Fil-
ter Separator (20A). To do so, remove the Air Filter Cover (18A). Remove the
Air Filter Element. Immerse the Air Filter Element in a mild solvent and squeeze
the Element several times to clean. Remove the Element from the solvent and
