Page 14
SKU 98838
For technical questions, please call 1-800-444-3353.
the Engine will be run in temperatures
below
32 degrees Fahrenheit, use
SAE 5W-
30
weight oil.
(See Figure D, prior page.)
To do so,
3.
unscrew
and remove the Oil Dipstick (65A). Pour engine oil into the oil
fill hole until the level of oil is even with the bottom edge of the oil fill hole (if you
cannot see the oil through the oil fill hole, then the oil is too low and more oil must
be added).
(See Figure D.)
Make sure to screw the Oil Dipstick (65A) firmly back into its Dipstick Hole.
4.
(See Figure D.)
To Fill The Fuel Tank:
Prior to first using the Generator, the Fuel Tank (31)
1.
must
be filled with high octane
unleaded
gasoline.
(See Figure D.)
To do so, remove the Fuel Tank Cap (34) and fill the Fuel Tank (31) with unleaded
2.
gasoline. Then, replace the Fuel Tank Cap. Thereafter, check the Fuel Gauge
(35) for the amount of unleaded gasoline. When necessary, refill the Fuel Tank.
(See Figure D.)
NOTE:
3.
Periodically, make sure to check the Fuel Filter (32) for excessive dirt and
debris. If necessary, remove the Fuel Filter and clean with compressed air.
(See Figure D.)
ThiS uNiT cAN POWER ThE FOLLOWiNG iTEMS
NOTE:
Wattages listed above are estimates. Check nameplate wattages on all loads
before connecting to Generator.
iTEM
RuNNiNG
WATTS
START-uP
WATTS
1 HP Air Compressor
1600
4500
Belt Sander
1200
2400
Pressure Washer
1200
3600
Refrigerator/Freezer
700
2200
1/2 HP Sump Pump
1050
2150
1/2 HP Well Pump
1000
2100
Miter Saw
1650
3000
1-1/2 HP Capacitor Start &
Run Motor
1400
3100
Central AC-32, 000 BTU
5000
6500
10” Table Saw
1800
4500
REV 09h
