Page 9
SKU 97594
For technical questions, please call 1-800-444-3353.
speciFications
Electrical Requirements 120 V~ / 60 Hz / 6.6A
Motor Speed
n
0
1,000/min
Chuck Size
1/2 Inch
Chuck Type
Keyless
unpacKing
When unpacking, check to make sure
that the item is intact and undamaged. If
any parts are missing or broken, please
call Harbor Freight Tools at the number
shown on the cover of this manual as soon
as possible.
instructions For
putting into use
read the entire iMportant
saFety inForMation section
at the beginning of this manual
including all text under
subheadings therein before set
up or use of this product.
to prevent
serious injury
FroM acciDentaL
operation:
turn the power switch of the
tool to its “oFF” position and
unplug the tool from its
electrical outlet before
assembling or making any
adjustments to the tool.
note:
For additional information regarding
the parts listed in the following pages,
refer to the Assembly Diagram near
the end of this manual.
Functions
This low-speed drill is suitable for
1.
heavy duty drilling operations.
The Trigger can be locked in the ON
2.
position for extended operation.
The Keyless Chuck allows the op-
3.
erator to install and remove drill bits
without the use of a separate key or
other tool.
operating instructions
read the entire iMportant
saFety inForMation section
at the beginning of this manual
including all text under
subheadings therein before set
up or use of this product.
tool set up
to prevent
serious injury
FroM acciDentaL
operation:
turn the power switch of the
tool to its “oFF” position and
unplug the tool from its
electrical outlet before
performing any inspection,
maintenance, or cleaning
procedures.
To insert a drill bit, hold the rear ring
1.
of the Chuck (2) with one hand while
turning the front ring with the other.
Open the jaws enough to allow the bit
to slide in. Turn the front ring the op-
posite direction to tighten the jaws on
the bit. Be sure the bit is centered in
the jaws. Tighten firmly by hand.
