SKU 92476 For technical questions, please call 1-800-444-3353.
PAGE 8
To Charge The Battery:
1.
The internal Battery of the Power System requires charging before use.
2.
The
initial charge requires 25 hours charge time using the accessory 120
VAC Adapter (15). Periodically, check the progress of the charge. Never leave
the Power System unattended for the entire charging period. Do not overcharge
the Battery, as damage to the Battery and/or 120 VAC Adapter will occur.
3.
Subsequent charges require 22 hours charge time using the 120 VAC
Adapter (15) or 20 hours charge time using the 12 VDC Cigarette Lighter
Plug (12). Do not overcharge the Battery, as damage to the Battery and/or 120
VAC Adapter or 12 VDC Cigarette Lighter Plug will occur.
4.
To charge the Battery using the 120 VAC Adapter (15), turn the Power Switch
(2) to its “CHARGE” position. Insert the Charging Plug of the Adapter into the
Power Input (1) located on the right side of the Power System. Plug the Adapter
into a 120 volt, grounded, electrical outlet. The RED Light on the LED Display (3)
will illuminate, indicating that charging is in progress. The Power System will be
fully charged when the RED Light automatically shuts off and both the top and
bottom GREEN Lights illuminate. Then, turn the Power Switch to its “OFF”
position.
5.
Once fully charged, disconnect the 120 VAC Adapter (15) from its electrical outlet.
Then disconnect the Charging Plug of the Adapter from the Power Input (1) on
the right side of the Power System. NOTE: The temperature of the Battery and/
or 120 VAC Adapter may increase slightly during use and shortly after use, which
is normal. The Battery may not accept a full charge if it is charged immediately
after use. Allow the Battery to cool to room temperature before recharging for
best results.
6.
To charge the Battery using the 12 VDC Cigarette Lighter Plug (12), turn the
Power Switch (2) to its “CHARGE” position. Insert the 12 VDC Cigarette Lighter
Plug into a 12 VDC cigarette lighter receptacle. Then, insert the other end of the
12 VDC Cigarette Lighter Plug into the Power Input (1) located on the right side of
the Power System. The RED Light on the LED Display (3) will illuminate, indicat-
ing that charging is in progress. The Power System will be fully charged when the
RED Light automatically shuts off and both the top and bottom GREEN Lights
illuminate. Then, turn the Power Switch to its “OFF” position.
7.
Once fully charged, disconnect the 12 VDC Cigarette Lighter Plug (12) from the
12 VDC cigarette lighter receptacle. Then, disconnect the other end of the 12
VDC Cigarette Lighter Plug from the Power Input (1) on the right side of the
Power System.
OPERATING INSTRUCTIONS
