SKU 91935
For technical questions, please call 1-800-444-3353
Page 19
Basic Operation:
1.
Make sure the Power Cord (116) of the Miter Saw is unplugged from its
electrical outlet.
Then, if necessary, make adjustments to the workpiece Holder
(21), Baffle Plate (20), cutting depth, and miter angle and/or bevel angle.
2.
Raise the Saw Blade (95) up to allow positioning of the workpiece.
3.
Check to make sure the Safety Button (124) and the Power Switch (122) are
operating properly.
3.
Tilt the Arm (46) until the desired bevel angle of cut is achieved as indicated on
the Scale Plate (39). Then, retighten the Bevel Lock Knob (40) to lock the Arm
in place.
(See Figure Q.)
ARM (46)
BEVEL LOCK KNOB
(40)
SCALE PLATE
(39)
FIGURE Q
To Adjust The Bevel Of Cut:
1.
WARNING! Prior to performing this procedure, make sure the Power
Cord (116) of the Miter Saw is unplugged from its electrical outlet.
2.
The bevel angle (or Saw Blade
tilt capacity) may be adjusted from 0 - 45 to the
left. To do so, loosen the Bevel Lock Knob (40) located at the rear of the Miter
Saw.
(See Figure Q.)
o
