SKU 91935
For technical questions, please call 1-800-444-3353
Page 18
To Adjust The Miter Angle:
1.
WARNING! Prior to performing this procedure, make sure the Power
Cord (116) of the Miter Saw is unplugged from its electrical outlet.
2.
The miter angle of a cut may be adjusted 0 - 45 to the right or left. To do
so, depress the Lock Lever (5) located at the front of the Work Table (9).
(See Figure P.)
3.
While the Lock Lever (5) is depressed, move the Miter Knob (1) to the right or left
until the desired miter angle of cut is indicated by the Scale located on the
Base (16). Then, release pressure on the Lock Lever to lock the Miter Saw in
place.
(See Figure P.)
o
6.
If the Saw Blade (95) touches the Work Table (9) or any other part of the Saw
Base (16), tighten the two Hex Bolts (87, 88) to raise the Saw Blade slightly until
it clears.
(See Figure P.)
FIGURE P
SAW BLADE (95)
WORK TABLE (9)
BASE (16)
HEX BOLT (87)
HEX BOLT (88)
KERF BOARD (77)
LOCK LEVER (5)
MITER KNOB (1)
3.
Loosen the two Hex Bolts (87, 88) and pull the Miter Saw’s Motor Housing (115)
down as far as it will go. Observe whether the edge of the Saw Blade (95)
passes completely through the Kerf Board (77).
(See Figure P.)
4.
If the Saw Blade (95) does not pass completely through the Kerf Board (77),
lower the Saw Blade slightly by turning the two Hex Bolts (87, 88)
counterclockwise.
(See Figure P.)
5.
After adjusting the two Hex Bolts (87, 88), press down on the Miter Saw and
make sure the Saw Blade (95) does not contact the bottom of the Work Table
(9) or any other part of the Saw Base (16).
(See Figure P.)
