SKU 90814
PAGE 11
ASSEMBLY AND OPERATING INSTRUCTIONS (continued)
Warning!! Always unplug the tool before inserting or removing bits.
3.
To remove a bit, press the red Bit Release (2) near the side of the chuck all the
way down and slide the bit out. To insert a bit, press the red Bit Release (2)
insert the bit all the way, release the button and turn the bit until the button clicks
out.
See FIGURE 7.
FIGURE 7
Bit
Bit
Release (2)
Chuck
High
Medium
Low
Speed Control (3)
FIGURE 8
4.
Tug on the bit to make sure it is securely in place. Plug in the tool. Set the Speed
Control (3) to Low, Medium or High Speed by matching up the center line on the
switch to the corresponding line. The longest line (High) refers to the fastest speed.
Do not adjust the speed while the tool is being used.
See FIGURE 8.
Note: This unit has a contact safety feature that requires the tip of the tool be pressed onto
the workpiece or the Trigger (7) won’t activate the tool.
5.
Grip the unit with both hands. After gently pulling on the Trigger (7), press the chisel
into the workpiece to activate the tool. Do not force the tool. Allow the tool to do the
work.
6.
When you are finished, move the bit off of the workpiece, release the Trigger (7), and
unplug the unit.
REV 02/04
