Page 8
For technical questions, please call 1-800-444-3353.
Item 67537
SAFET
y
O
PERA
TION
M
AINTENAN
c
E
SETUP
Operating Instructions
Read the ENTIRE IMPORTANT SAFETy INFORMATION section at the beginning of this
manual including all text under subheadings therein before set up or use of this product.
Tool Set Up
TO PREVENT SERIOUS INJURy FROM AccIDENTAL OPERATION:
Make sure that the Power Switch is in the off-position and unplug the tool from
its electrical outlet before performing any procedure in this section.
Attachment Installation
1. Use the Hex Key to remove the Cap Screw (1)
and Flange (2) from the end of the Spindle (3).
2. Install the desired accessory by placing the
accessory’s mounting holes against the fitting pins
on the Spindle. Accessories may be mounted at
angles up to 90° left or right of straight ahead.
Note:
The long Cutter Blade should only be used
in the straight ahead position. See Figure B.
cAUTION!
When attaching the Scraper Blade or
Cutter Blade, orient the accessory so that the blade
faces AWAY from the handle to avoid injury.
3. Replace the Cap Screw and Flange while holding
the accessory. Make sure the cupped side of
the Flange is toward the tool. While holding the
attachment over the pins on the tool, tighten the
Cap Screw onto the Spindle using the Hex Key.
Torque snugly (approximately 10 ft-lb).
cAUTION!
Make sure that the accessory is
held securely in place by the four fitting pins on
the Spindle as the Cap Screw is tightened.
Fitting Pins
Spindle (3)
Flange (2)
cutter Blade
cap Screw (1)
Figure B: Example of Installed Attachment
4. After securing, the attachment should not move
on the Spindle. If it can move with the power
off, remount it, making sure that the holes on the
attachment line up with the pins on the Spindle.
Tighten the Cap Screw securely.
Note:
For sanding, first attach the Sanding Pad to the
tool, then align a sheet of Sandpaper over the pad and
press into place. Once a Sandpaper corner becomes
worn, turn it 120° or replace the sheet with a new one.
Содержание 67537
Страница 1: ......
