Page 7
For technical questions, please call 1-800-444-3353.
SKU 67097
Washer
(2)
Hex Bolt (1)
Figure 2
3. Insert Hex Bolt (1) through Washer
(2). Line up the holes on attachment
with the tabs on the Washer.
(See
Figure 2.)
Tighten the Hex Bolt into Spindle
4.
using the Hex Wrench (41). Tighten
until securely in place.
OPERaTIng InSTRUCTIOnS
Read the EnTIRE IMPORTanT
SaFETY InFORMaTIOn
section at the beginning of this
manual including all text under
subheadings therein before set
up or use of this product.
Accessory Attachments - This multi-
purpose tool includes Sandpaper (38)
and a Sanding Pad (40) for sanding
wood or removing paint from surfac-
es, a Cutting Blade (42) to cut wood
and soft metal such as copper piping,
and a Scraper (3) which can be used
for scraping paint or wall paper from
flat surfaces.
Designate a work area that is clean
1.
and well-lit. The work area must not
allow access by children or pets to
prevent injury and distraction.
Secure loose work pieces using a
2.
vise or clamps (not included) to pre-
vent movement while working.
Once Battery Pack is fully charged,
3.
slide Pack into back of housing.
While holding Tool with both hands,
4.
slide Power Switch forward to acti-
vate.
Do not allow contact between Sand-
5.
paper, Scraper, or Blade and work-
piece until tool is at full speed.
Avoid contact with foreign objects
6.
such as metal screws and nails when
sanding, scraping, or cutting.
Do not apply excessive pressure on
7.
tool. Allow tool to do the work.
When finished, slide Power Switch
8.
back turn off tool. Allow it to com-
pletely stop before setting down.
To replace the sanding paper, simply
9.
pull off the pad.
Remove Battery Pack and place in
10.
Charger, making sure Charger is out
of reach of children. Remove attach-
ment and wipe clean.
