SKU 46935
For technical questions, please call, 1-800-444-3353.
Page 4
- Lead from lead-based paints
- Crystalline silica from bricks and cement or other masonry products
- Arsenic and chromium from chemically treated lumber
Your risk from these exposures varies, depending on how often you do this type
of work. To reduce your exposure to these chemicals: work in a well ventilated
area, and work with approved safety equipment, such as those dust masks that are
specially designed to filter out microscopic particles.
(California Health & Safety Code § 25249.5,
et seq.
)
Maintenance
. For your safety, maintenance should be performed by a qualified
technician.
The warnings, cautions, and instructions discussed in this instruction manual
cannot cover all possible conditions and situations that may occur. It must be
understood by the operator that common sense and caution are factors which
cannot be built into this product, but must be supplied by the operator.
use proper size and type extension cord
. If an extension cord is required, it
must be of the proper size and type to supply the correct current to the tool without
heating up. Otherwise, the extension cord could melt and catch fire, or cause
electrical damage to the tool. See the chart below for appropriate extension cord
size. Longer extension cords require larger size wire. If you are using the tool
outdoors, use an extension cord rated for outdoor use (signified by “WA” on the
jacket).
RECOMMEndEd MInIMuM WIRE gAugE FOR EXTEnSIOn CORdS*
(120/240 VOLT)
nAMEPLATE
AMPERES
(at full load)
EXTEnSIOn CORd LEngTH
25 Feet
50 Feet
75 Feet
100 Feet
150 Feet
0 – 2.0
18
18
18
18
16
2.1 – 3.4
18
18
18
16
14
3.5 – 5.0
18
18
16
14
12
5.1 – 7.0
18
16
14
12
12
7.1 – 12.0
18
14
12
10
-
22.
23.
24.
unpacking
When unpacking, make sure the parts listed on page 7 are included. If parts are missing or
broken, call Harbor Freight at the number on the cover of this manual as soon as possible.
Maintenance
Warning!!
Make sure the Breaker Hammer is unplugged before doing any maintenance.
1.
Wipe the tool with a lint free cloth after each use. Remove all dust and grit from the
tool.
2.
Add a drop or two of a lightweight oil to the Switch assembly area to lubricate the
Switch
Knob (#87)
.
3.
Examine the tool before each use. Make sure the Chisel Bit is sharp and not dull or
cracked. Replace worn or broken bits with approved replacement bits from Harbor
Freight Tools.
4.
Store in temperatures no lower than 50-60° F.
REV 06k; 07b
