Page 8
For technical questions, please call 1-888-866-5797.
Item 57226
Instructions For Putting Into Use
Read the ENTIRE “IMPORTANT SAFETY INFORMATION” section at the beginning of this
manual including all text under subheadings therein before set up or use of this product.
TO PREVENT SERIOUS INJURY FROM ACCIDENTAL OPERATION:
Turn the Power Switch of the tool off and unplug the tool from its electrical outlet
before assembling or making any adjustments to the tool.
Note:
For additional information regarding the parts listed in the following
pages, refer to the Assembly Diagram near the end of this manual.
Set-Up
Y
our Rotary Tool will require some set-up prior to operation.
To assist you with set-up, please refer to the following
instructions. Also see the Parts List and Assembly Diagrams
near the end of this manual.
It is important that you read the entire manual to become
familiar with the unit
BEFORE
you use the Rotary Tool.
Before setting-up your Rotary Tool, be sure that you have
all parts described in the Parts List.
Assemble attachments based on the intended use of
the tool.
Set-up and disassemble your Rotary Tool Set for each use.
Put back all pieces in the case provided and store in the
case to ensure that no pieces are lost.
To Insert Accessories:
1. Insert Collet (2, Accessory C) into the shaft.
Slide the Collet Nut (1) over the Collet. Insert
the desired accessory fully into the Collet.
2. Press down on the Lock Button (4) while turning
the Collet Nut. The shaft will click into place.
3. With the Shaft locked in place, use the
Wrench (Accessory I) to tighten the Collet Nut.
Note:
Some cutting wheels, polishing tips and
accessories need to be attached or inserted into
another shaft or mandrel to be used. In these
cases, please note the following instructions.
4. Thread the accessory onto the screw of the
Mandrel (Accessory L) into the Collet. Following
the preceding steps, tighten the Collet Nut.
To Remove Accessories:
1. Press down on the Lock Button while
turning the Collet Nut counterclockwise.
You will feel the Shaft click into place.
2. With the Shaft locked in place, use the Wrench to
loosen the Collet Nut and remove the accessory.
Work Piece & Work Area Set-Up
1. Designate a work area that is clean and well-
lit. The work area must not allow access by
children or pets to prevent distraction and injury.
2. Route the power cord along a safe route to reach
the work area without creating a tripping hazard or
exposing the power cord to possible damage. The
power cord must reach the work area with enough
extra length to allow free movement while working.
3. Secure loose work pieces using a vise or clamps
(not included) to prevent movement while working.
4. There must not be hazardous objects, such
as utility lines or foreign objects, nearby that
will present a hazard while working.
5. You must use personal safety equipment
including, but not limited to, ANSI-approved
eye and hearing protection, as well as
heavy work gloves and work apron.
6. Before beginning work, plan and provide
for sparks and debris that will fly off the
work surface.
CAUTION!
Always have
access to a type AAA fire extinguisher.
