Chevrolet P 1989, Схемы проводки

Страница: 7 / 143

Figure 19—Weather-Pack and Metri-Pack Connectors
Figure 20 Twisted Wire Repair
4. Terminal (138) by inserting J-35689 (139) into the
connector body (137) to depress the locking tang
(138), then push the wire and terminal through the
connector body (figure 20).
• Snip off the old terminal unless the terminal is to be
reused, reshape the locking tang.
5. 5mm (0.2-inch) of the wire insulation (130).
* Terminal cavity of the connector body.
[ >< ] Install or Connect (Figure 19)
1. Terminal (136) on the wire.
• Crimp and solder the terminal.
2. Terminal (136) into the connector cavity by pulling
the wire on the seal side of the connector until the
locking tang (138) is fully seated.
3. Seal (120) by pressing the seal into the connector
body (137) until it is fully seated.
4. Connector until the primary lock (121) engages.
WIRING REPAIR
The wire repair is very important for the continued
reliable operation of the vehicle. This repair must be done
as described in the following procedures.
Twisted Wires (Figure 20)
[<>] Remove or Disconnect
1. Jacket (30).
2. Twisted wires (91).
Figure 21 —Twisted/Shielded Wire Repair
3. Insulation from the wire.
[><] Install or Connect
1. Splice clip (93).
• Crimp.
• Solder.
2. Electrical tape wrap (94) on wires.
3. Outer electrical tape wrap (95).
Twisted Wires/Shielded Cable (Figure 21)
[<>] Remove or Disconnect
1. Jacket (100).
2. Unwrap aluminum/mylar tape (101).
3. Drain wire (102).
A. Leads.
5, Insulation on the leads.
[><] Install or Connect
1. Splice clips (103).
2. Crimp and solder the splice clips (104).
3. Electrical tape (105) on the splices.
WIRING DIAGRAMS 13
WIRING DIAGRAMS 14
120. Connector Seal
121. Primary Lock
122. Secondary Lock Staple
123. Secondary Lock
124. terminal Barrel
125. Secondary Lock
128. Lock Opened
127. Lock Opened
128. J-28742 Terrninal Remover
129. Wire
130. 5 mm (0.2 inch)
131. Terminal
132. Roll Crimp
133. Roll Crimp
134. Terminal Insulator
136. Metri-Pack Series 150 Female Terminal
137. Connector Body
138. Locking Tang
139. J-35689 Terminal Remover
VIEW B
F-02349
100. Jacket
101. Aluminum/Mylar Tape
102. Drain Wire
103. Splice Clip
104. Crimp and Solder
105. Electrical Tape Wrap
106. Drain Wire Splice Clip, Crimped And Sol-
dered.
107. Outer Electrical Tape Wrap.
B-06231
90. Jacket
91. Twisted Wires
92. Splice Clip
93. Crimp and Solder
94. Electrical Tape Wrap
95,. Outer Electrical Tape Wrap.
B-06230