Headlamp High/Low-Beam Changer
Push the turn signal/multifunction lever away from
you to change the headlamps from low beam to
high beam.
A light comes on in the
instrument panel cluster if
the high beams are on
while the ignition is turned
to ON/RUN.
To change the headlamps from high beam to low beam,
pull the turn signal lever toward you.
Flash-to-Pass
This feature lets you use your high-beam headlamps to
signal a driver in front of you that you want to pass.
To use it, pull the turn signal/multifunction lever toward
you until the high-beam headlamps come on, then
release the lever to turn them off.
Windshield Wipers
Use this lever located on the right side of the steering
wheel to operate the windshield wipers. The ignition
must be turned to ON/RUN to operate the windshield
wipers.
HI (High Speed): This position is for wiping at a high
speed.
LO (Low Speed): This position is for steady wiping at a
low speed.
3-8
Содержание 2008 Optra
