CHESTER Voyager Lathe, Руководство по эксплуатации

Страница: 14 / 66

D. Jog Switch (D, Fig 13), press and release immediately to advance the spindle
position.
2. Headstock Gear
Change Levers (E, Fig 13) – located on the front of the headstock, move the
levers according to the speed chart for the desired speed setting.
3. Leadscrew/Feed Rod
Direction Lever (F, Fig 13) – Located on the front of the headstock, Moving the
lever up will allow the carriage tot travel in the direction of the tailstock; moving
the lever down will allow the carriage to move in the direction of the headstock
when the spindle is rotating in either direction.
Do not move the lever whilst the machine is running.
4. Feed/Leadscrew
Selector Lever (G, Fig 13) – located on the front of the headstock, used when
setting up for threading or feeding.
Caution: in the “A” position, never run the lathe at speeds higher than 650rpm.
5. Feed/Leadscrew
Selector Lever (H, Fig 13) – located on the front of the gearbox and is used when
setting up for feeding and threading. Positions “F” and “D” are for the feed rod.
Position “E” and “C” are for the feed screw. Position “0” is neutral.
6.
Lock Knob (I, Fig 13) –
Located on the front of the gearbox. When the knob is in the six o’clock position,
the feed/leadscrew selector lever (J, Fig 13) can be adjusted. With the knob in
the 12 o’clock position, the same lever will be locked.
7.
Feed/Leadscrew
Selector Knob (J, Fig 13) – located on the front of the gearbox, it is used when
setting up for feeding and threading.
8.
Compound Lock (A, Fig 14) – This is a Hex
Socket Screw located on the left side of the
compound slide. Turn clockwise to lock and
counter-clockwise to unlock.
9.
Carriage Lock (B, Fig 14) – The lock handle is
located on the top of the carriage, turn it
clockwise to lock the carriage and counter-
clockwise to unlock the carriage.
Caution: The carriage must be unlocked
before engaging automatic feeds to prevent causing damage to the lathe.
10. Longitudinal Traverse
Handwheel (D, Fig 14) – located on the apron assembly, rotate the handwheel
clockwise to move the apron assembly towards the tailstock, rotate counter-
clockwise to move the apron assembly towards the headstock.
14