CHESTER Voyager Lathe, Руководство по эксплуатации

Страница: 10 / 66

Coolant Preparation
Caution! Follow the manufactures recommendations for use, care and
disposal.
Remove the rear access cover on the tailstock end and make sure that the coolant
tank has not shifted during transport and is properly located under the recovery
chute.
Fig 9.
Pour three gallons of coolant mix into the chip pan and, once the power has been
connected, turn on the coolant pump and check to see that the coolant is cycling
properly. Once this has all been checked, secure the coolant door back onto the
stand.
Electrical Connections
Warning! All electrical connections must be completed by a qualified
electrician! Failure to comply may cause serious injury and/or damage to the
machinery and property!
Lathe Power Source Junction Box: Remove the cover. Run the main power through
the strain relief bushing and attach the ground, followed by the power leads.
Replace the cover.
Main Power Switch: Located on the rear of the machine. Turns the power to the
machine on and off.
Make sure that the lathe is properly grounded.
To ensure that the lathe has been connected correctly, pull up the forward/reverse
lever, the spindle should rotate in a counter-clockwise direction when viewed from
the tailstock. If the spindle rotates clockwise, turn the power off and change any two
10