CHESTER 836 TURRET MILL, Руководство по эксплуатации

Страница: 6 / 23

6
Shipping Container Contents
1. Mill
1. Flat Way Cover (rear)
1. Accordion Way Cover (front)
1. Knee Crank
1. Drawbar
1 Tool Box:
1. Hex Wrench Set (1.5 - 10mm)
1. 17/19mm Combination Wrench
1. #2 Cross Point Screw Driver
1. #2 Flat Blade Screw Driver
1. Oil Can
1. Hand wheel
1. Adjustable Wrench
5. Handles for Handwheels
1. Operator's Manual
Unpacking and Clean-Up
1. Finish removing the sides and top of the
crate.
Leave the mill bolted to the skid until it is
ready to be moved to its final location.
2. Clean all rust protected surfaces with
kerosene or a light solvent. Do not use
gasoline, paint thinner, or lacquer thinner.
These will damage painted surfaces.
3. Cover all machined surfaces with a film of
light machine tool oil to inhibit rust.
4. Remove wood block from below the knee.
Raising the Head
1. Remove handwheel (A, Fig. 1).
2. Loosen four cap nuts (B, Fig.1) ½ turn to
unlock the head.
Do not
remove these
nuts unless you are prepared to remove
the head.
3. Use a 19mm socket and breaker bar on
adjusting nut (C, Fig. 1) to rotate the head.
Fig.1