CHERUBINI A510038, Инструкция по эксплуатации

Страница: 10 / 24

LIMIT SWITCHES AND OBSTACLE DETECTION
(Only motors with mechanical limit switches)
After having memorized the first remote control and properly assigned the rotation
direction, the control unit is ready for operation.
Run two complete ascent and descent cycles with the A and C buttons on the remote
control to memorise the operating times and enable obstacle detection.
In the event of obstacle detection during closing, the control unit will stop the motor
without any further movements. In the event an obstacle is detected during opening with
super-sensitivity active, the control unit performs a safety movement in reverse equal to
about ¼ of the awning travel.
After the last confirmation movement, the motor starts a series of UP and DOWN
movements: the first lasts 2 seconds, the next ones go to the limit switch positions
(motors with mechanical limit switches) or long movements - max 10 seconds (motors
with electronic limit switches). To properly associate the UP and DOWN buttons, press the
button corresponding to the motor movement for one second as indicated below:
The motor stops: the UP
and DOWN buttons are
now properly associated.
?
29
Every time you connect the power supply to the control unit, you have 3 hours to
store the first remote control. After this time, the ability to store the remote control is
disabled. To reset the timer of the function you have to disconnect and reconnect the
power supply to the control unit.
AUTOMATIC DISABLING OF THE FIRST
REMOTE CONTROL SETTING FUNCTION
T1 (1 sec)
A
C
E
NG
L
IS
H