• Make sure to always use only specified micro centrifuge tubes made from plastic
and designed to withstand centrifugal forces of at least 2000 g.
• Do not operate the centrifuge without the rotor being properly attached to the
shaft. Re-check by trying to pull it up manually, especially after the rotor has been
changed or re-assembled.
• Do not move the centrifuge while it's under operation.
• Do not fill the tubes while they are in the rotor. Liquid spillage may harm the unit.
• Do not put hands in the rotor chamber unless the rotor has completely stopped.
• Do not centrifuge flammable, explosive or corrosive materials.
• Do not use solvents or flammable media near this or other electrical equipment.
• In case the unit is dropped from the table, please check the casing for any
cracks/damage.
• The centrifuge and its components are non autoclavable.
• Do not use the centrifuge in any manner not specified in these instructions.
7. INSTALLATION
,--+--+--ON/OFF
SWITCH
,..,.--+--+-- POWER
SOCKET
This Micro Centrifuge is supplied in a packaging box. Open the box, then gently
remove the centrifuge from the box and plug in the power adaptor pin before
connecting to the main power source. The instruction manual and the accessories
should be kept with the centrifuge. Please keep all packaging in safe storage for at
least 2 years for warranty purposes.
Make sure the rotor is tight to avoid any accident. Load the rotor with the micro tubes
for centrifugation. Place the ON/OFF switch to "o", rear, set the desired speed and
time, and close the lid to start centrifugation.
For more clarification refer to the RCF chart below:-
