C
HEETAH
864XR
V
IDEO
M
ATRIX
S
WITCHER
Publication 81-9059-0595-0, Rev. C
October 2010
Proprietary Information of
PESA
4-2
•
+28
V (green)
•
+2.5
V (green)
•
+1.2
V (green)
c.
Observe the Matrix Frame Controller CCAs and verify status of the following LEDs
and the LED display (single or dual CCAs):
•
Single CCAs: the
Control Status
display indicates -
ØSNGL OK
(red)
•
Dual CCAs: the
Control Status
display of the active module indicates –
Active OK
while the other module indicates
Standby.
•
Active
(green – illuminated on single and
Active
modules only)
•
+28
(green)
•
+5
(green)
•
+3
(green)
d.
On the Output Monitor module (if present), the
Power OK
LED is illuminated
(green).
e.
On each of the Input and Output modules, the
Power
LED is illuminated (green).
f.
If installed and on the 3500 Series System Controller module(s), the following
conditions exist:
1)
Dual 3500 Series System Controller module configurations:
•
If both 3500 Series System Controller modules’ active/standby switches
are in the
Standby
or
Active
position, then Frame Slot A determines the
active module. Otherwise, the active module is selected by the
individual module’s switch settings.
2)
Any 3500 Series System Controller configuration, the
Active
(amber – on the
active module) and
Run
(green) LEDs are illuminated.
At the end of this sequence, there should be no LED indicators that are
blinking or any red LEDs illuminated on any of the I/O and Matrix
modules/cards. If so, perform troubleshooting to correct the status before
proceeding to the next section.
