5
6.2 Print All
In the Print All Menu the data saved in memory can be output to a
printer through the serial port RS232 connection. (See 10.3 RS232 in
Communications section for more information)
6.3 Print Selected
In this menu, select the data range to print. Touch “MODE/UP” to adjust
the value, touch “SAVE/PRINT” to shift to the next position. Press
“ZERO/EXIT” to cancel; touch “MENU/ENTER” to confirm.
6.4 Upload
1.
Choose in EDMS software the ‘Upload Memory Data
From Gauge’ selection.
2.
On the TTC screen, select Upload. The screen should display
‘Upload…’ as shown below.
3.
While ‘Upload…’ is visible on the screen, click ‘Start
Acquisition’ on the EDMS software.
4.
Data should populate the table on the right hand side of the
software screen.
6.5 Delete Selected
Select the range of data to be deleted. Touch “MODE/UP” to adjust the
value. Press “SAVE/PRINT” to shift to the next position. Touch
“ZERO/EXIT” to cancel; touch “MENU/ENTER” to confirm.
6.6 Delete All
In this menu, a prompt will appear. All data will be deleted by selecting
“YES” and canceled by selecting “NO” or pressing “ZERO/EXIT”.
7. SYSTEM
Under the System menu, several parameters may be set.
7.1 Display Mode
Two display modes may be selected: Digital and Graphic.
7.2 Auto Power Off
To maximize battery life, the power can be set to shutdown after non-
use. The time can be set in this menu. The range is 01-99 minutes. When
set to “99” the gauge will never turn off. Touch “MODE/UP” to adjust the
value, touch “SAVE/PRINT” to shift to the next position. Press
“ZERO/EXIT” to cancel; Push “MENU/ENTER” to confirm and exit.
7.3 Backlight
Under this menu, the backlight can be set to ON, OFF or have an auto
shutdown time. Touch “MODE/UP” or “DOWN” keys to shift to the next
position. Press “ZERO/EXIT” to cancel. Press “MENU/ ENTER” to confirm
and exit.
