Compliance Information
Quantum Smart-1 600-M Appliances Getting Started Guide | 28
n
Do not disassemble, crush, or puncture batteries.
n
Do not store or place your battery pack next to or in a heat source such as a fire, heat-generating
appliance, car or exhaust vent. Heating battery cells to temperatures above 65 °C (149 °F) can
cause explosion or fire.
n
Do not attempt to open or service batteries. Do not dispose of batteries in a fire or with household
waste. See Battery Disposal instructions.
Additional instructions for rack-mounted systems
Caution
-
If installed in a closed or multi-unit rack assembly, the operating
ambient temperature of the rack environment may be greater than room ambient.
Therefore, consideration should be given to installing the equipment in an
environment compatible with the maximum ambient temperature (Tma) specified
by the manufacturer. For more information, see your product documentation.
n
Your rack kit has been approved only for the rack cabinet provided. It is your responsibility to ensure
that installation of the equipment into any other rack complies with all applicable standards. The
manufacturer disclaims all liability and warranties with respect to combinations of equipment with
any other rack.
n
Before installing your equipment in a rack, install all front and side stabilizers. Failure to install
stabilizers can allow the rack to tip over.
n
Always load from the bottom up, and load the heaviest items first.
n
Do not overload the AC power supply branch circuit that provides power to the rack.
n
Do not stand or step on any components in the rack.
Warning
- Slide/rail mounted equipment is not to be used as a shelf or work space.
Do not add weight to slide/rail mounted equipment.
n
Reliable earthing of rack-mounted equipment should be maintained. Particular attention should be
given to supply connections other than direct connections to the branch circuit (e.g. use of power
strips).
The following statement applies only to rack-installed products that are GS-Marked:
This equipment is not intended for use at workplaces with visual display units, in accordance with §2 of the
German ordinance for workplaces with visual display units.
Warning
- For equipment using -(48-60)V DC power supplies, a qualified electrician
must perform all connections to DC power and to safety grounds. Do not attempt
connecting to DC power or installing grounds yourself. All electrical wiring must comply
with applicable local or national codes and practices.
Caution
- Systems using -(48-60)V DC power supplies may have a connection
between the earthed conductor of the DC power supply circuit and the earthing
conductor.
