Configuring 16000 Appliances
16000 Appliances Getting Started Guide | 33
3.
Click
RAID Volumes
.
The window shows volume and disk information.
To monitor the RAID status of the storage devices using SNMP:
Set up SNMP traps to send information about the RAID.
Use OID:
1.3.6.1.4.1.2620.1.6.7.7
For more about how to configure the SNMP settings on the appliance, see the
Gaia
Administration Guide
for the applicable version.
To hot swap a storage device:
Important
- Make sure that there is at least one fully synchronized storage device in the system.
1.
When the system is up, remove the failed storage device.
2.
Wait 15 seconds.
The appliance recognizes that you removed a storage device.
3.
Insert a new storage device. If necessary, you can reboot the appliance with one storage device and
install the new storage device later.
The system automatically adds the new storage device to the RAID configuration.
Initial Configuration
Configure the appliance with the First Time Configuration Wizard. See the
Installation and Upgrade Guide
related to the software version.
Go to the
Installing Security Gateways on Appliances
section, and see the instructions to use the First
Time Configuration Wizard.
