Stage Designer™ 50 User Manual
13
Revised: 2008-08-25 16:16:53
5. Playback
This controller uses the Channel Faders and Channel Flash buttons for multiple uses. In this
occurrence, Channel Faders 13-24 (37-48) are used for the playing back of Scenes already recorded.
This is only when the controller is in the
Chase
◄►Scene
mode. In this instance,
Master Fader A
will control the manual fader controls, while
Master Fader B
will control the Scenes being played
back.
P L AY I NG A S CE NE
A Scene can contain 1,000 steps. The term steps and scenes are used interchangeably.
Action
1)
Tap the Mode Select button to select
Chase
◄►Scene
mode
.
2)
Tap the
Page
button to select the
correct page the program you wish to
run is located.
3)
Push master Slider B to its maximum
position (fully down).
4)
Move the desired
Channel
slider (13-
24) to its maximum, and the
Scene
will
fade in depending upon current fade
time.
5)
Move the channel slider to adjust the
output of the current program.
Notes
The current mode is indicated by the 3 LEDs. Red is
the
Chase◄►Scene
. Yellow is
2-scene preset A/B
.
And, Green is
1-24
single mode.
You may press and hold down the relevant
Flash
button for the
Scene
to trigger the button
momentarily.
P L AY I NG A S CE NE T O AUDI O T RIG G E RI NG
Action
1)
Select your
Scene
as described in the
above section.
2)
Tap the
Audio
button until its LED lights,
indicating
AUDIO
mode is active.
3)
Use the
Audio Level
slider to adjust the
sensitivity.
4)
To return to normal mode, tap the
Audio
button a second time, causing its LED to go
out.
AUDIO
mode is disengaged.
Notes
This is the process of using the built-in microphone,
or using the audio jack located on the rear of the
controller to use an alternative audio source for
triggering of the
Scenes
.