Chauvet Q-Wash 575, Руководство пользователя

Страница: 3 / 19

1. B
EFORE
Y
OU
B
EGIN
What is included
¾
1 x Q-Wash 575™
¾
HMI 575W Lamp
¾
Power Cord
¾
Warranty Card
¾
User Manual
Unpacking Instructions
Immediately upon receiving a fixture, carefully unpack the carton, check the contents to ensure that
all parts are present, and have been received in good condition. Notify the shipper immediately and
retain packing material for inspection if any parts appear damaged from shipping or the carton itself
shows signs of mishandling. Save the carton and all packing materials. In the event that a fixture
must be returned to the factory, it is important that the fixture be returned in the original factory box
and packing.
AC Power
Figure 1 - AC Voltage Switch
To determine the power requirements for a
particular fixture, see the label affixed to the back
plate of the fixture or refer to the fixture’s
specifications chart. A fixture’s listed current
rating is its average current draw under normal
conditions. All fixtures must be powered directly
off a switched circuit and cannot be run off a
rheostat (variable resistor) or dimmer circuit, even
if the rheostat or dimmer channel is used solely
for a 0% to 100% switch. Before applying power
to a fixture, check that the source voltage
matches the fixture’s requirement. Check the
fixture or device carefully to make sure that if a
voltage selection switch exists that it is set to the
correct line voltage you will use.
100V
100V
115V
115V
208V
208V
230V
230V
240V
240V
50Hz
50Hz 60Hz IN IN
60Hz
Select volt age
T
o
Ballast 230V/50Hz
T
o
Ballast 230V/60H
z
Lamp Contr
o
l to PCB in
AC-100-230V
INPUT
To TRANSFORMER
See the product overview for the
location of these switches.
Warning! Verify that the voltage select switch on your unit matches the line voltage applied,
and that the frequency select switch on your unit matches the frequency of the
power in your region. Also verify that you are using the correct fuse value for your
operating voltage. All fixtures must be connected to circuits with a suitable Earth
Ground. Damage to your fixture may occur if these instructions are not followed.
P
OWER
C
ABLE
P
IN
I
NTERNATIONAL
B
ROWN
Live L
B
LUE
Neutral N
Y
ELLOW
/G
REEN
Earth EG (Ground)
O
PERATING
V
OLTAGE
M
UST USE CORRECT
FUSE
120V 15A
230V 10A
Q-Wash 575 User Manual 3
8/3/2007 9:10:00 AM