COLORdash™ Quad User Manual
9
3/30/2009 4:01 PM
The fuse is located
inside this compartment.
Remove using a Phillips
#2 head screwdriver.
FUSE
3.
S
ETUP
Fuse Replacement
With a Phillips #2 head screwdriver, unscrew the fuse holder from its housing. Remove the
damaged fuse from its holder and replace with exact same type fuse. Screw the fuse holder back
in its place and reconnect power.
Lens Assembly Installation/Replacement
The COLORdash
™ Quad comes with 26 x 6° lens assembly pre-installed from the factory. However, there
are 2 other optional lens kits 15° degree
(CL20X15)
and 30° degree
(CLENS3009)
available as accessories,
which will alter the beam angle. Please follow the below instructions for proper replacement/installation.
1.
Remove the front cover, using a Phillips#2 screwdriver. There are 10 screws for this cover.
2.
After removing the front cover, remove the screws that hold the lens assembly in place.
There are 4 lens assemblies for each fixture. There are 4 Phillips #2 screws that secure
each of these assemblies in position.
Note: use care when performing this procedure, as this gives you direct access
to the LEDs, which are very fragile.
3.
The same assembly is to be reinstalled with the new lenses in place and the process is
complete.
Warning!
1. When replacing the lens assembly, please make sure that the power is
disconnected from the fixture beforehand.
2. You must also be VERY CAREFUL when opening this fixture. Improper
handling on the behalf of the user may void the
manufacturer’s 2-year
warranty.
Disconnect the power cord before replacing a fuse and always
replace with the same type fuse.
2. LENS Assembly
(1 of 4)
1.
Front cover
LED PCB