Setup
ART-150W & ART-252W User Manual
8
2005-01-31/12:52
ART-150W
ART-252W
Do Not Tilt beyond -90°
and +90° as illustrated.
Installation
O R I E N T AT I O N
This fixture is designed to be installed upright at all times. It achieves an Ingress Protection Rating of 55
only when the fixture’s base is attached to a level horizontal surface on.
M O U N T I N G
1)
If connected, be sure to always disconnect from main power before installing fixture.
2)
The ART-252 comes with foot brackets that should be attached to the fixture’s base prior to the fixed
installation. Bolt foot brackets to the bottom of the fixture. (A)
3)
The ART-150 is constructed with mounting brackets.
4)
Bolt fixture onto a leveled floor surface using holes marked by (B).
Power configuration
The factory power settings will be printed on the fixtures serial label. Make sure that your local AC voltage
matches that required by the fixture.
115V / 50Hz AC or
230V / 60Hz AC
Both ART-150 and ART-252 are equipped with a 3-conductor electrical cable for connecting to an AC
power supply. (D) The cable enters the fixture through a cable gland that fits 5 to 10mm diameter cables.
Because the ART fixtures are built for permanent exterior installations please adhere to the following
safety and installation precautions.
