Operating Instructions
ART-150W & ART-252W User Manual
12
2005-01-31/12:52
Menu Functions
DMX-512 addressing {Addr}
This mode enables the use of a universal DMX controller device. Each fixture requires a "start address"
from 1 to 511. A fixture requiring one or more channels for control begins to read the data on the channel
indicated by the start address. In the case of the Spectrum™, only 1 channel is necessary. Each fixture
can be incrementally numbered.
S ET T I N G T H E S T AR T I N G AD D R E SS
1) Press
the
MENU
button until the display reads
.
2) Press
the
ENTER
button to select DMX
addressing. Once selected the display will read
either a 1 or any other number that may have
previously been set. You must make a selection
within 6 seconds.
3) Press
the
(-)
and
(+)
buttons to increase or decrease values until the desired value is achieved.
4) Press
the
ENTER
button to activate selection.
Stand-Alone, Show Selection {ShNd}
By linking the units under a Show mode, the first unit can direct additional units to create a synchronized
light show. If the fixture is not connected to a controller then it will automatically enter a stand-alone mode.
S ET T I N G T H E S H O W
The Spectrum™ contains 4 built in programs that affect the time that each color changes
.
Show Mode 1
5 second color chase
Show Mode 2
10 second color chase
Show Mode 3
20 second color chase
Show Mode 4
1 minute color chase
.
1) Tap
the
MENU
button until the display reads
.
2) Press
the
ENTER
button to select this function. The selection is confirmed when the display begins to
blink. You must make a selection within 8 seconds.
3) Press
the
(-)
and
(+)
buttons to toggle between the Shows available.
4) Press
the
ENTER
button to activate selection.
Blackout Mode {bLNd}
1) Tap
the
MENU
button until the display reads
.
2) Press
the
ENTER
button to select this function. The selection is confirmed when the display begins to
blink. You must make a selection within 8 seconds.
3) Press
the
(-)
and
(+)
buttons to toggle between [
] for
yes
to blackout or [
] for
no
.
4) Press
the
ENTER
button to activate selection.
The following Caution statement refers to Universal DMX Controller devices only.
Some controllers are factory configured to control a specific range of channels per fixture. For example, you may
have a controller pre-set to control 10 channels per fixture for a total of 12 fixtures. In this case you would be
required to separate all fixtures in 10 channel increments instead of the true number of channels your particular
fixture utilizes.
